Spiralfast Wire joiners


Creating stay wires...


Tight stay wire loops can be made with high-tensile wire using Tension Ties.
Loop the wire one or more times around the posts with the end about two-thirds of the distance between the posts.
Wrap a tension tie on the end of the wire.
Apply a straining tool as shown between the first and last turns so that there is room to apply the Tension Tie.
Strain up the wire then wrap the second end of the Tension Tie onto the wire past the jaw of the straining tool.
Wrap the centre of the Tension Tie around the wire first so that the ends of the wire are locked under the centre.
Remove the tool and cut off the excess wire leaving at least 5cm (2 inches) overlap.


Contact us
Distributors
Home